Tejas Mk1A Sports Improved Canopy for Enhanced Visibility & Combat Awareness

Photographs have recently surfaced of a Tejas Mk1A fighter aircraft, designated LA5033, sporting a redesigned canopy. Experts speculate the striking redesign is intended to significantly enhance pilot visibility, especially during the crucial moments of aerial combat encounters.

The most notable change is a distinctive bulge at the canopy's rear. This enlarged design appears to provide additional space for the pilot's helmet.

The extra space facilitates better head movement, potentially improving situational awareness and minimizing blind spots. For fighter pilots locked in intense dogfights, enhanced visibility is a significant tactical advantage for tracking and engaging adversaries.

This design change is seen as a likely response to insights gained from pilots operating the earlier Tejas Mk1 variant, of which the Indian Air Force (IAF) currently has nearly two squadrons in service. The new canopy design directly addresses a key element of close-quarters combat effectiveness.

While the advantages of the new canopy seem clear, Hindustan Aeronautics Limited (HAL), the Tejas program's lead developer, has not yet provided official statements confirming the rationale for the change. This leaves some room for speculation within the defence community about additional purposes the new design might serve.

The redesigned canopy is a noteworthy development step for the Tejas Mk1A program. Enhanced combat visibility directly contributes to pilot efficiency and success.

The upcoming first flight of the Tejas Mk1A is a much-anticipated milestone in India's drive for an advanced, indigenously-produced fighter jet. The new canopy represents a clear upgrade in its capabilities.

 

[Prashu Sam]

Wow and they are also doing taxi trials. Jai hind

 

[NSR]

The new canopy really looks nice and surely going to increase the visibility for the pilots.
A very good decision indeed.

But I sincerely hope that the bulge does not affect the normal aerodynamics forces experienced by the fighter from its original design.

 

[sanket]

Der aaye Durust aaye well done ADA/HAL....................

 

[Chhole Bhature]

Are you sure that it's not camera 📷 orientation?

 

[ABHIJIT APSINGIKAR]

HAL just does not seem the understand the gist to mass production and modern assembly line operations. Then some people seem surprised that they delay endlessly. Once the production specification has been frozen all subsequent upgrades need to be rolled out in a phased manner. U dont roll out upgrades to Flight Computer and Canopy that can potentially disrupt the production cycle just like that. All upgrade options ought to have been consolidated and incorporated in Block 1 upgrade package. The fact that they are rolling it out at this late stage, where they have technically missed the deadline for delivery suggests they were anyway running way behind schedule and all these attempts are to create an alibi to justify inordinate delays in delivering Tejas MK1A.

 

[PRO]

Are you sure that it's not camera 📷 orientation?

Their is second pic shows little bluge at rear end

https://twitter.com/x/status/1773020949677216025

 

[Apocalypse gupta]

This must be one of the 80 odd upgrades that were mentioned, that the mk1A has over the mk1. Waiting eagerly for the first flight. All the best!!!

 

[ABHIJIT APSINGIKAR]

This must be one of the 80 odd upgrades that were mentioned, that the mk1A has over the mk1. Waiting eagerly for the first flight. All the best!!!

Bro production/assembly line operations are not as simple as to just introduce upgrades in adhoc manner. you need to schedule resources carefully to optimize production resources. Any changes to the original specification which was frozen at the onset of signing a production contract would be unadvisable as it disrupts supply chain and interrupts production cycle. Its best to consolidate many of the small changes and modifications that are advised or required and then roll out in structured periodic block upgrade programs. These upgrade programs can further be classified into minor and major., while minor can be applied between production batches , major modifications would require to be introduced in tranches.

You never introduce changes when in production run. That just disturbs the entire cycle and just creates unnecessary complications.

 

[Apocalypse gupta]

Bro production/assembly line operations are not as simple as to just introduce upgrades in adhoc manner. you need to schedule resources carefully to optimize production resources. Any changes to the original specification which was frozen at the onset of signing a production contract would be unadvisable as it disrupts supply chain and interrupts production cycle. Its best to consolidate many of the small changes and modifications that are advised or required and then roll out in structured periodic block upgrade programs. These upgrade programs can further be classified into minor and major., while minor can be applied between production batches , major modifications would require to be introduced in tranches.

You never introduce changes when in production run. That just disturbs the entire cycle and just creates unnecessary complications.

These upgrades were finalised lomg time ago when tejas mk1a was being designed, after receing feedback from IAF, and to meet indigenisation targets. Nobody is introducimg them in adhoc manner.

This upgrade is well planned. I agree with what you said about production in batches etc. That is what is happening here. Another order of 100 aircrafts will be placed with further upgrades in some years time after receiving feedback on mk1As.

 

[charminar_waale_ismail_bhai]

These upgrades were finalised lomg time ago when tejas mk1a was being designed, after receing feedback from IAF, and to meet indigenisation targets. Nobody is introducimg them in adhoc manner.

This upgrade is well planned. I agree with what you said about production in batches etc. That is what is happening here. Another order of 100 aircrafts will be placed with further upgrades in some years time after receiving feedback on mk1As.

HAL really needs to up its game in supply chain. I understand Abhijit's point since supply chain can make or break a product early on in its lifecycle.
China is a manufacturing behemoth simply because it masters the supply chain for manufacturing IC chips to oil tankers, everything.
HAL needs to recruit aervice.of industry experts who would help it streamline their assembly and thus increase production output.

 

[ABHIJIT APSINGIKAR]

These upgrades were finalised lomg time ago when tejas mk1a was being designed, after receing feedback from IAF, and to meet indigenisation targets. Nobody is introducimg them in adhoc manner.

This upgrade is well planned. I agree with what you said about production in batches etc. That is what is happening here. Another order of 100 aircrafts will be placed with further upgrades in some years time after receiving feedback on mk1As.

Canopy is still ok but introduction of a component as significant as flight control computer that basically controls FBW software is a major change and that should never be done so carelessly.

 

[NSR]

Their is second pic shows little bluge at rear end

Thank you.

But I sincerely hope that the bulge does not affect the normal aerodynamics forces experienced by the fighter from its original design.
Or else then DRDO/ADA has to tweak the Flight Control System.

It is always a NO NO for late changes to a ground breaking fighter bomber on which India will rely on for decades.

 

[Apocalypse gupta]

Canopy is still ok but introduction of a component as significant as flight control computer that basically controls FBW software is a major change and that should never be done so carelessly.

I dont think it was. Mk1a carries an indigenous flight control computer, and it has been certified. It was planned to be included in the 70-80 upgrades over the mk1.

 

[ABHIJIT APSINGIKAR]

Canopy is still ok but introduction of a component as significant as flight control computer that basically controls FBW software is a major change and that should never be done so carelessly.

Actually! now that I think about it even canopy would be problematic. Say HAL ordered a company A to supply canopy assemblies with certain specification, after the initial contract was signed in 2021. The company prepares sub contractors and starts production as per original specification, but now suddenly as per improvements requested right before deliveries are due to be made, now the supplier has to reconfigure his manufacturing process to accommodate modifications. Which again takes more man hours due to extra process involved. The extra process involved in curing a thicker canopy will again have a cumulative effect on delivery which again will impact HAL production run of a minimum 16 fighters per annum as requested by IAF. In short its now safe to assume that HAL is likely to miss the production target of delivering 16 aircraft per annum.

 

[Apocalypse gupta]

HAL really needs to up its game in supply chain. I understand Abhijit's point since supply chain can make or break a product early on in its lifecycle.
China is a manufacturing behemoth simply because it masters the supply chain for manufacturing IC chips to oil tankers, everything.
HAL needs to recruit aervice.of industry experts who would help it streamline their assembly and thus increase production output.

I agree, but this is just beginning. The focus on domestic defence production is very recent one. Previously it was thought that we can just buy from foreign countries. Focus on indigenisation was limited to strategic sectors like ballistic missiles. But now we are going for a comprehensive indigenisation of almost everything. Just like china. China started this 20 years ago. We started 5 years ago. It will take us another 15 years to reach the level of indigenisation that chinese currently have.

 

[SK]

I hope that there is a change in the position of the Air-Gun/Canon so that Tejas-Mk1A can have a total of 9 usable Hard-points with 2 of them being mostly used for Electronic Equipment.

 

[Akshat]

Wow and they are also doing taxi trials. Jai hind

Doing taxi trials 2 months after they were supposed to deliver 3 jets. Wow indeed.

 

[The Presence]

Actually! now that I think about it even canopy would be problematic. Say HAL ordered a company A to supply canopy assemblies with certain specification, after the initial contract was signed in 2021. The company prepares sub contractors and starts production as per original specification, but now suddenly as per improvements requested right before deliveries are due to be made, now the supplier has to reconfigure his manufacturing process to accommodate modifications. Which again takes more man hours due to extra process involved. The extra process involved in curing a thicker canopy will again have a cumulative effect on delivery which again will impact HAL production run of a minimum 16 fighters per annum as requested by IAF. In short its now safe to assume that HAL is likely to miss the production target of delivering 16 aircraft per annum.

It wasn't decided just before the delivery. It was decided a long time ago when the IAF gave feedbacks on Mk-1 to HAL.

 

[ABHIJIT APSINGIKAR]

It wasn't decided just before the delivery. It was decided a long time ago when the IAF gave feedbacks on Mk-1 to HAL.

The question is, was it decided before the MK1A contract was finalized or after it was finalized? Once the contract is signed the specifications are frozen and will remain unchanged at least for the first few batches .Changes like canopy would be organically absorbed during production down the line. The company usually will instruct vendors about certain change in specifications and as it would require time to produce, in the mean time production will continue apace. When new specification canopy would be ready to be supplied normally they will be rolled out in normal production.

 

[Pramkumar]

it seems clearly the feedback on the MK1 is taken and few changes what ever possible is taken place with MK1A first. So we expect more good product developments. this is not possible when we buy from other countries or when the screw driver job is done

 

[CCPSmasher]

LADIES AND GENTLEMEN, HAL IS ON TRACK TO DELIVER THE PROMISES SQUADRON OF TEJAS MK1A IN 2147.

 

[Sandeep]

The new Tejas MK1A canopy seems to have a more aerodynamic and smoother curve at the top whereas in the previous Tejas MK1 jets the curve seems to be more sharper and visibly obvious. This makes the Tejas MK1A canopy fly much better and smoother aerodynamically.

Another crucial improvement and change in the Tejas MK1A canopy will be to install a HUD, glass cockpit, three multi function displays and two smart standby displays etc which will improve visibility in general with installing better equipment and technology on all sides of the jet.

Now that the new Tejas MK1A canopy has been developed, tested and certified the private and government sector need to quickly start manufacturing it as quickly as possible. The government should issue a license to more private companies who can manufacture it quickly, efficiently, safely, cheaply and to the highest quality possible. This will drive down manufacturing costs and any possible delays that usually come with bureaucrats.

 

[Avada kedavra]

So what's so great about this mk1a.
What radical changes they do to take it so long time?

 

[Saptarshi Ray]

Doing taxi trials 2 months after they were supposed to deliver 3 jets. Wow indeed.

Change your attitude, two three months don't matter much, it isn't two three years.